Description
Kristall 41360 Carbide Nail Drill Bit features a frustum/cone shape with a green coarse cross-cut. It is designed for fast removal of dense artificial nail materials, including polygel and hard gel, as well as nail correction, shortening and shaping of extensions. It can also be used for selected pedicure and podology procedures.
Key Features
-
Frustum / rounded cone shape for efficient material removal
- 6 mm working diameter
- 15 mm working surface length
-
Green marking — coarse cut
-
Cross-shaped teeth for active material removal
- Carbide construction
- Standard 2.35 mm shank
- Suitable for e-file manicure, pedicure and podology
- Designed for dense artificial nail materials
- Suitable for nail correction and shaping
Applications:
- Removing polygel and hard gel
- Removing dense artificial nail coatings
- Removing lifted material during nail correction
- Correcting the length and shape of extended nails
- Working with thickened natural nails
- Rough filing of artificial or thickened nail plates
- Shaping gel applied with upper forms
- Selected pedicure and podology procedures
Green Coarse Cross-Cut
The green marking indicates a coarse cut. The large cross-shaped teeth are designed for active cutting and fast reduction of dense artificial material. This makes the 41360 particularly suitable when a significant amount of gel or polygel needs to be removed efficiently.
How to Use
Insert the bit into a compatible e-file handpiece and select the rotation speed according to the material and procedure. Work with controlled, continuous movements and avoid excessive pressure or prolonged contact in one area.
The coarse green cut is intended primarily for dense artificial materials and material reduction, rather than aggressive filing directly on the natural nail plate.
Disinfection & Sterilization
Disinfection:
- After use, place the carbide bit into a suitable disinfectant solution. The concentration and exposure time should follow the instructions of the selected disinfectant.
- Clean the working surface from product residue and filings using a nylon or brass bur-cleaning brush.
- For more effective cleaning, the use of an ultrasonic cleaner is recommended.
- Rinse the bit under running water, followed by distilled water.
- Remove excess water with a clean, dry towel.
Sterilization:
Autoclave: Place the cleaned and dried bit into a sterilization pouch and seal it before placing it in the autoclave.
Sterilization cycle: 132°C, 2 bar, 20 minutes.
Dry heat sterilization: Place the cleaned and dried bit into a dry-heat sterilizer.
Sterilization cycle: 180°C, 60 minutes.
